Machine Parts For Reuse Newsgroup Discussion Forum > Small Size Parts
> Used
> Mechanical
> Milaukee
> Press brake dies tool form open closed hem varable gage
Press brake dies tool form open closed hem varable gage
This item is being relisted to correct any previous listing errors!
Any length to 24 foot is in stock at time of listing.
Gage varys but for quoting purpose this item is for 16 Ga. or lighter material
Our 131 132 (sketch shown) Ten Foot set is being quoted.
Hem tool forms two operations in your press brake without removing tool.
Upper section forms acute angle middle section closes hem, either closed
or open by using a mandrel this to allow a lock form type hem.
Unit shown has optional air lift via foot pedal.
This to allow middle section to stay down for only forming upper acute angle.
eliminating travel of the middle section.
Typically Springs and stripper bolts are used and middle section rides up and down.
Should you require more info on this or other products or to contact us directly
visit us at
