Machine Parts For Reuse Newsgroup Discussion Forum > Small Size Parts
> Used
> Electronic
> Clieveland
> Brinsea H222 digital humidity management module
Brinsea H222 digital humidity management module
Provides continuous accurate control, water metering and features a digital display which clearly and continuously shows the Relative Humidity (RH) within the incubator, allowing you to both accurately monitor and adjust the humidity level in forced draft incubators as required, to help ensure maximum hatching success. Poor control of incubator humidity is the #1 cause of poor hatching rates. The H222 will compensate for fluctuations in ambient humidity level, allowing the user complete control.
Brinsea H222 Digital Humidity Management Module
* Provides continuous accurate control, water metering and
direct digital display of current condition in % Relative Humidity.
* Control of incubator humidity is the no.1 cause of confusion and misunderstanding in incubation procedure, frequently resulting in poor hatching rates.
* The solution to the problem is: Brinsea's new H222 Digital Humidity Management Module.
* The module suits most fan-assisted incubators and provides continuous,direct and highly accurate relative humidity
* It also controls the amount of water evaporated within the incubator to maintain the humidity level set by the user.
* The new H222 Humidity Management Module features a digital display which clearly and continuously shows the Relative Humidity (RH) within the incubator, allowing you to both accurately monitor and if necessary adjust the humidity level in forced draft incubators as required, in order to help ensure maximum hatching success.
* The Humidity Management Module will compensate for fluctuations in ambient humidity level, day or night, and allows the user complete control over incubation environment.
* The unit stands beside the incubator, and is connected to it
by a thin electrical lead and a flexible tube for water supply.
* The sensor mounts through a 25mm (one inch) diameter hole in the incubator wall, pre-cut on all Brinsea forced draft incubators.
* The H222 is also suitable for any brand incubators holding up to about 10,000 eggs.
Precision Bulk-polymer design.
15vAC feed from control module to sensor
Humidity Management Module requires a 115 Volt source. @ 6VA
(230v 50Hz) available upon request
* H222 Digital Humidity Management Module
* Pack of Evaporating pads (12+ incubations worth)
