Machine Parts For Reuse Newsgroup Discussion Forum > Small Size Parts
> Used
> Electrical
> Chicago
> New clarke 180EN 180 en mig welder 220V gas/no gas
New clarke 180EN 180 en mig welder 220V gas/no gas
*NEW* Clarke USA 180EN WE6524 MIG/Fluxcore Wire Welder
This NEW in factory sealed box Clarke 180EN MIG/Fluxcore Wire Feed Welder is easily converted from Gas to Fluxcore welding and will weld 1/4 in. steel in a single pass! Electronic wire speed control and 6 variable heat settings allow you to precisely adjust the welder to your needs. Operates on 220 volt electrical supply. You will be getting this NEW in factory sealed box Clarke 180EN welder along with roll of wire, welding mask, chipping hammer, and manual but NO regulator. Check out the new Clarke gas regulator if you will be doing gas welding in my other listings!
* Welds 1/4" in a single pass
* Solid state electronic heat control with large PC board for better wire speed control.
* Weld steel, aluminum, stainless, copper and cast, requires correct wire and gas.
* Automatic thermal safety switch prevents overload.
* Simple to operate and portable.
* Max Open-Circuit Voltage: 30
* Variable wire feed control 0 - 700 IPM
* Circuit Breaker Req: 25 amps
* Duty Cycle: 20% at 100% output
* Duty Cycle: 30% at 85% output
