Machine Parts For Reuse Newsgroup Discussion Forum > Small Size Parts
> New
> Mechanical
> Dallas
> Comstock-castle gas 41" funnel cake, doughnut fryer
Comstock-castle gas 41" funnel cake, doughnut fryer
MODEL: 2941SF- FRIES 8-8" FUNNEL CAKES AT A TIME
MODEL: 2941SF- FRIES 8-8" FUNNEL CAKES AT A TIME, CONSISTENT TEMPERATURE, INSTANT RECOVERY. FRIES AS FAST AS YOU CAN POUR.
CONSTRUCTION: Easy cleaning, corrosion resistant stainless steel finish, welded with aluminized inner framing. Double wall construction with heavy insulation combined with a special flue design for cooler operation. Adjustable 4" stainless steel legs for easy leveling. Installation clearances for non-combustible surfaces are 2" on sides and 6" in the rear, combustible surface clearances are 6" and 6". Hinged front door panel protects controls.
BURNERS: Long life, cast iron H pattern burners combined with a special V shaped tank design directs heat for excellent air circulation. CONTROLS: Snap Action thermostat for fast recovery, 100% safety shut off, high limit control for back-up safety, automatic standing pilot and brass burner valves. Pressure regulators are set at the factory for natural gas and easily convertible to propane. Optimal pressures are 4" WC for natural gas and 10" WC for propane. Manifold size is 3/4" NPT. All controls are tested and confirmed in good working order. Calibration and adjustments are the responsibility of the installer. TANK: Easy cleaning, corrosion resistant stainless steel with angled bottom 3/4" gate valve for rapid draining. ACCESSORIES: Single large baskets, stainless steel tank covers, gas hoses, cleaning supplies, equipment stands and casters are listed in the price list. FLOOR MODELS: Tubular stainless steel legs and stainless steelstabilizing under shelf to bring the tank surface to 36". TECHNICAL SPECS
Proof of installation date must be submitted on the factory supplied Warranty Registration/Installation Checklist prior to work being performed.
B) Such repair shall be performed within fifty (50) miles from an office of a Factory Authorized Service Agency or sub-agent or any other licensed agent approved in writing by Factory.
C) The equipment has not been damaged, altered or misused.
D) The equipment is properly installed, adjusted, operated and maintained in accordance with national, state and local codes for commercial kitchens and in accordance with the installation instructions provided with this product.
E) The warranty serial number plaque affixed to the appliance has not been defaced, obliterated or removed.
F) An acceptable report of any claim under this warranty shall be supplied to Factory within thirty (30) days of the work performed. EXCLUSIONS:
Factory shall have no obligation as to any product(s) which have been misapplied, mishandled, abused, misused, subjected to harsh chemical action or poor water/gas quality, modified without written approval from the factory, damaged by flood, fire or other acts of nature.
B) Re-calibrations associated with the replacement of a defective part otherwise covered under this warranty for labor will be covered to the extent of one (1) service call (i.e. the call during which the part is replaced).
C) Factory assumes no responsibility for travel costs beyond 100 miles round trip, travel other than overland and overtime costs of repair.
D) Factory excludes paint and porcelain finish, gasket material, ceramic material from normal coverage.
E) Factory liability on a claim of warranty shall not exceed the price of the material and/or service which caused the claim.
F) This warranty is limited and is in lieu of all other warranties, expressed or implied. Factory employees or agents shall not be held liable for any claims of personal injury or consequential damage or loss.
G) Factory assumes no responsibility for installation, adjustments, diagnosis or normal maintenance such as lubrication of springs or valves. RETURN:
Questions Call (***)945-9993 Toll Free-(***)316-9390 Local
