Machine Parts For Reuse Newsgroup Discussion Forum > Small Size Parts
> New
> Electrical
> Dallas
> 2 channels dc remote control 0V output switch RP201
2 channels dc remote control 0V output switch RP201
Remote Control Simple open/close Switch with 0v output contact
One remote to perform 2 different tasks for 2 different device.
Here is the gadget just made for that purpose, use this kit as a simple switch to make contact open or close remotely with up to 2 application.
Prefect for home, automobile and boat electronics gadgets or any projects you need to apply a switch to perform open/close function, REMOTELY!
Kit can be mounted into anything that you want it to be able to OPEN and CLOSE, ON or OFF with a click of the remote control.
Compact size with mounting holes make it easier for installation.
Comes with 2 remote controls, 1 receiver box and 2 mounting screws.
This 2 channel kit had programmed with its unique code so there will be no interference, even if you have 2 or more kits operate side by side.
Input voltage: 12Vdc (can be operating between 10V to 18Vdc)
Remote response range: 60ft, range can be extended further depend in area, device setup and remote control battery strength
Relay rated: 12~30VDC@10Amp, 110~250VAC@10Amp.
Receiver Box Dimension: 1 7/8" x 1 7/8" x 1" (4.7cm x 4.7cm x 2.5cm)
(this kit will not output any voltages, it only act as an open or close switch at the output, if you also need a 12 feed at the output, please use our RM102 kit)
Black wire: ground or negative connection for input power
Green wire: Antenna, no connection required, mount it where the best signal can be received
White wire A & B: Relay output switch contact connector
**For 110/220VAC, please use an AC to DC adapter**
