Machine Parts For Reuse Newsgroup Discussion Forum > Medium Size Parts
> Non functional
> Electrical
> Cleveland
> Delta ru-50 overarm pin router 2 hp 1 ph 60 x 30" table
Delta ru-50 overarm pin router 2 hp 1 ph 60 x 30" table
You are considering an Invicta / Delta RU50 Overarm Pin Router. This item is used, but is in good overall condition. It has been tested here and found to be in good operating condition.
* Motor: 2 HP, 230V single phase
* Spindle Speeds: 9,000 and 18,000 RPM
Note: This machine has had a 60" X 30" X 1-1/4" thick work table added to it. The following measurements were taken from the manual and some of them may not apply to this machie with the added table.
* "Original" work table size: 17-5/8" X 23-5/8"
* Height From Floor: Max 42: / Min: 37-1/2"
* Clearance between table and spindle: Max 8-1/8" / Min 7/8"
As mentioned above, this machine has had a heavy 60" X 30" X 1-1/4" work table added to it. The table can be easily removed if needed. You will also receive the following items:
* Collets: Qty 2, 1/2" and Qty 1, 1/4"
* Bits: Qty 5, 1/2" and Qty 6, 1/4". (Most of the bits look new in their original pack).
* Double-end Guide Pins: Qty 3, 3/8 & 1/2". Qty 1, 1/4 & 5/16" Qty 1, 1/8 & 3/16"
* Spindle / Collet Wrenches: 2
* Original Manual & Parts List
This machine requires air to operate the up/down travel of the spindle, via a pneumatic foot pedal. It has a standard air line quick connect on the back for easy hook-up. It also has a quick connect under the spindle throat with a air gun for blowing off debris. The four, round steel pieces in the picture are leveling feet that fit in the bottom of the legs.
