Machine Parts For Reuse Newsgroup Discussion Forum > Medium Size Parts
> New
> Electronic
> New * * clarke 190EN mig/fluxcore welder 220V gas/no gas
New * * clarke 190EN mig/fluxcore welder 220V gas/no gas
*NEW* Clarke USA 190EN WE6484 MIG/Fluxcore Wire Welder (220V)
This NEW in factory sealed box Clarke 190EN MIG/Fluxcore 220V Wire Feed Welder is easily converted from Gas to Fluxcore welding and will easily weld 1/4 in. steel in a single pass! Electronic wire speed control and 6 variable heat settings allow you to precisely adjust the welder to your needs and is fan cooled for better performance. Operates on 220 volt electrical supply. You will be getting this NEW in factory sealed box Clarke 190EN welder along with roll of wire, welding mask, chipping hammer, and manual as well but NO regulator. Check out the new Clarke gas regulator to go along with this if you will be doing gas welding in my other listings!
* Easily welds 1/4" in a single pass
* Fan cooled for better performance
* Solid state electronic heat control with large PC board for better wire speed control
* Weld steel, aluminum, stainless, copper and cast iron, requires correct wire and gas
* Input 230V, 60HZ, 25 Amps, 1 ph
