Machine Parts For Reuse Newsgroup Discussion Forum > Medium Size Parts
> New
> Electrical
> Milaukee
> Atlas metal frost top drop-in unit 1/5HP |wf-2
Atlas metal frost top drop-in unit 1/5HP |wf-2
Atlas Metal Frost Top Drop-In Unit 1/5HP |WF-2
Frost Top Drop-In Unit Self Contained Refrigeration System 19-1/2" x 25-1/4" x 1"
DESCRIPTION: The RM series refrigerated cold pan eliminates the mess and expense of ice in your cold food displays. In addition, this cold pan, 9" deep, has copper tubing wrapped around its side walls to meet the strictest health department codes. Thedrop-in pan can be installed in virtually any counter and can be provided as fully self-contained - just plug it in and turn it on - or remote, where there's a need to locate the compressor at a different location. The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory applied gasket so that is can be installed in the finest wood fixtures without marring the counter top. The frost top is constructed of stainless steel and stands 1" above the counter top for an eye-catching display. When turned off, the condensate melts into the full perimeter gutter, sloped to a 1/2" drain.
o "Quick", frost top, stands 1" above counter for attractive display - ideal for pre-plated cold food
o Fully insulated for maximum efficiency and energy savings
o Factory applied gasket - makes installation a snap and seals units to the counter top, thus eliminating seepage
o NSF certified - WF series is UL recognized steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top.
FROST TOP: Constructed of 14 gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish. The top is formed to stand 1" above the counter top and is provided with a 1/2" full perimeter gutter to collect melted condensate; a 1" I.P.S. drain is provided. The frost top has copper tubing firmly soldered to the exterior bottom.
INSULATION: The pan is fully insulated with high density fiberglass and polystyrene, 1-1/2" thick, and enclosed with an 18 gauge galvanized steel outer lines. The entire unit is removable without the use of tools.
REFRIGERATION SYSTEM: (WM series only) The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is fully charged with
SPECIFICATIONS: CFC free refrigerant and ready to operate.
NOTE: Proper ventilation must be provided in counter.
ELECTRICAL: (WF series only) The unit will be wired for 15 amps., 120 volt, single phase operation with an on/off thermostat switch and pilot light. A 6' long, 3-wire cord and plug (NEMA 5-15P) will be provided. Specifications subject to change without notice.
Frost Top Drop-In Unit, galvanized steel outer liner, with on/off switch and pilot light, 1"IPS drain, 1/5 HP
