Machine Parts For Reuse Newsgroup Discussion Forum > Large Size Parts
> Used
> Electrical
> Cleveland
> 1 h.p. motor air compressor, drill press, table saw
1 h.p. motor air compressor, drill press, table saw
TYPE CAPACITOR START, R.P.M. 1725
SHAFT 5/8" WITH KEYWAY ACTUAL SHAFT DIA. IS .618 SEE EXPLANATION IN DESCRIPTION SHAFT LENGTH 1 7/8"
DIR. OF ROTATION - EITHER WAY. INFO GENERALLY SUPPLIED ON COVER WAS MISSING. I HAVE INCLUDED PAPER WHICH CLEARLY SHOWS HOW TO CHANGE VOLTAGE OR DIRECTION (VERY SIMPLE).
I USED THIS MOTOR ON A SEARS AIR COMPRESSOR. THE SHAFT WAS WORN SOME AND KEYWAY HAD A FEW NICKS. I TURNED SHAFT DOWN TO .618 DIA. (.007 ) THE KEYWAY HAS A FEW NICKS BUT HAS A GOOD FIT AND WOULD POSE NO PROBLEM FOR GOOD PULLEY FIT. I DIS-ASSEMBLED & PUT NEW SEALED FOR LIFE BEARINGS. STARTER ASS'Y CAPACITOR ALL INTERNALS VERY GOOD CONDITION. TO SOLVE UNDERSIZE SHAFT I MADE A .003 CIRCUMFERENTIAL SHIM. FOR PULLEY TO RUN TRUE. THE PULLEY SUPPLIED IS A 2 3/4 DIA. 6 RIB "V" BELT SERPENTINE TYPE USED ON SEARS AIR COMPRESSORS.
IT RUNS TRUE WITH SHIM INSTALLED. I WILL ALSO INCLUDE A PULLEY CUSTOM BORED TO .618 SLIP FIT WITH KEYWAY UP TO 4" DIA. FOR "B" BELT AT NO CHARGE. YOU SPECIFY OR USE YOU PULLEY WITH THE SHIM. THIS IS A VERY NICE UTILITY MOTOR FOR VARIOUS APPLICATIONS & COULD BE USED ON TABLE SAWS, JOINTERS ETC. BY DIFFERING PULLEY SIZE FOR R.P.M.
